QFCL BC Combi descaling

Odoo CMS - a big picture

QFCL BC Combi Oven Descaling 

 

Contact us »

Instructions/qualifications 


Received special training and was certified within 12 months or less. 

Report Type *

Date/Time of inspection *

Inspection Report Prepared by *

Employee/Badge # *

Other personnel participating

Remarks/Notes (i.e reason for Ad-Hoc or Re-Inspection)

Equipment location*


Always wear suitable protective clothing including appropriate gloves, and eye protection. *

If Safety PPE is not available stop and notify your Manager

Never operate the Combi when descaler has been applied or while descaling. *

Descale only when the Combi is cold *

Immediately wipe up any leaked or spilled descaling fluid *


Turn ON the Combi at the Control Power Service Disconnect switch located below the hand shower *

Turn ON the Combi with the ON/OFF key *

Open the door to the cooking compartment *

Run a manual steam generator rinse cycle *

Remove the cap from the descale port located at the top of the Combi *

While the steam generator is filling with water, use a funnel to add 3/4 gallon of DISSOLVE descaler solution into the descaling port *

After the automatic fill cycle has ended, turn OFF the Combi with the ON/OFF key, and at the Control Power Service Disconnect switch located below the hand shower *

Add cold tap water through the descale port until descaling solution enters the cooking compartment through the steam port or until the descaling port overflows *

Let the Descaler work for 1 hour *

Run a manual steam generator rinse cycle *

After the automatic fill cycle has ended, turn OFF the Combi with ON/OFF key, and at the Control Power Service Disconnect switch located below the hand shower *

Add water through the descale port until water enters the cooking compartment through the steam port or until the descaling port overflows to rinse descaler from the area above the normal water fill level *

Replace the descale port cap *

After the Automatic Fill ends, run a manual steam generator rinse cycle *

Run Combi mode for 30 minutes at 212° F with Crisp & Tasty function *

Run a manual steam generator rinse cycle. This is the final rinse. The Combi is now ready for normal operation *